User's Manual

CNR d'IS E D C applicables aux
ISEDC RSS WARNING
This device complies with licence-exempt RSS standard(s).
FCC STATEMENT AND ISEDC NOTICE
FCC ISEDC PRECAUTIONS
1. This device complies with Part 15 of the FCC Rules
Operation is subject to the following two conditions:
5
model. If not operated correctly, the model could possibly cause injury to you
or spectators and damage to property.
•
Do not alter or modify the model, as doing so may result in an unsafe or
unflyable model.
•
You must check the operation of the model before every flight to ensure that
the model has remained structurally sound.
CAUTION: Changes or modifications to this product not expressly approved by
the party responsible for compliance may void the user’s authority to operate
the equipment.
BATTERY WARNINGS
This product is equipped with a rechargeable LiPo battery.
Please pay attention to the following cautions for safe use:
•
ALWAYS KEEP OUT OF REACH OF CHILDREN AND ANIMALS.
•
ALWAYS recycle or dispose of LiPo batteries properly.
•
Parental guidance is recommended when installing batteries.
•
Land your model immediately when the LEDs flash to indicate that the
battery power is low. Recharge the battery before attempting another flight.
A dangerous situation can occur when attempting to recharge an over-
discharged battery!
•
Before turning off the transmitter, ALWAYS unplug your battery from the
quadcopter after use.
•
NEVER store your quadcopter with the battery plugged into the quadcopter.
•
NEVER disassemble, allow puncture (eg: animal bite) or modify the battery
pack in any way.
•
Over-charging, using an incompatible charger, charging a damaged battery,
can result in a catastrophic failure resulting in the battery swelling, emitting
smoke, and/or catching FIRE!
•
DO NOT charge your battery if it becomes swollen or hot. Let the battery
cool and recycle it.
•
NEVER use a common household fire extinguisher on a LiPo fire. If a Class
“D” extinguisher is not available, keep a supply of sand accessible when
charging. Dumping sand on the battery will extinguish a LiPo chemical fire.
•
NEVER allow the batteries to become wet.
•
NEVER put batteries in the pocket of any clothing.
•
Only use the included charger or a charger designed for LiPo batteries to
charge the flight battery.
•
DO NOT attempt to use the included charger with NiCd or NiMH
battery packs.
•
NEVER attempt to charge LiPo cells with a charger set to another
battery type.
•
NEVER charge inside a vehicle.
•
DO NOT leave the charger unattended while charging.
•
ALWAYS place a battery being charged on a fireproof surface.
•
Disconnect the battery and unplug the charger immediately if either
becomes hot! However, it is normal for the charger to get warm.
•
NEVER allow the battery temperature to exceed 140° F [60° C].
•
Disconnect the battery from the charger and carefully move the battery to a
fireproof location if the battery begins to swell or smoke!
•
ALWAYS disconnect the battery and remove the charger from the USB port
when not in use.
•
It is best to store your batteries inside a metal container in a cool, dry
location at 1/2 charge (3.7V per cell). Storing a fully discharged battery may
cause irreversible damage to the battery.
•
DO NOT dispose of battery into fire or heat.
•
DO NOT use or store the battery near an open
fire or heater.
•
DO NOT strike, pierce or throw the battery
against a hard surface.
For more information about LiPo batteries,
please read the document at
www.dromida.com/lipos.php
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Remark: This device is in accordance with the digital device grade B limitation and
the 15th regulation of FCC. This limitation requires reasonable anti-interference
protection around the residence. The device can transmit radio waves during
use and can interrupt the mobile communication without proper installment.
Interruption will occur for special device. If the device does interrupt the radio or
television, please turn the device off and then turn it on to adjust. Below are some
resolutions for your reference:
•
Move the receiving antenna.
•
Enlarge the distance between the device and receiver.
•
Try to not connect the device and the receiver on the same circuit.
•
Ask for professional help from experts.
3. This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus set out in the Radio Interference Regulations of
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR
TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
90-DAY LIMITED WARRANTY
Dromida
®
guarantees this kit to be free from defects in both material and
workmanship at the date of purchase. This warranty does not cover any
component parts damaged by use or modification. In no case shall Dromida’s
liability exceed the original cost of the purchased kit. Further, Dromida reserves
the right to change or modify this warranty without notice. In that Dromida has no
control over the final assembly or material used for final assembly, no liability shall
be assumed nor accepted for any damage resulting from the use by the user of
the final user-assembled product. By the act of using the user-assembled product,
the user accepts all resulting liability. If the buyer is not prepared to accept the
liability associated with the use of this product, the buyer is advised to return this
kit immediately in new and unused condition to the place of purchase. To make a
warranty claim, go to dromida.com/support.
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
ISEDC
ISEDCISEDC
Le présent appareil est conforme aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
Le présent appareil est conforme aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.