- Hobart Welders Welder User Manual

 A complete Parts List is available at www.HobartWelders.com
OM-230 455 Page 19
Ref. 803 640-A / 801 400-B
5-6. Sequence Of Piercing Operation
Connect work clamp to a clean, paint-free
location on workpiece, as close to cutting
area as possible.
Hold torch at an angle to
the workpiece. Press
trigger. Pilot arc starts.
Move torch to upright
position 90° to surface.
Start cutting when arc
pierces workpiece.
Maintain torch position
and continue cutting.
Release trigger. Postflow cooling
continues after releasing trigger.
 Postflow must finish before
trigger will restart pilot arc.
 The pilot arc starts immediately
when trigger is pressed.