Installation Guide

measurements of the drain and waste location beneath the unit.

3. Place the bathtub in the designated space ensuring that the drain

and waste locations match with that of the tub and adjust the

balancing feet as needed, using a level.

(figure 1)

- 1 -

INSTALLATION MANUAL

INSTALLATION STEPS

1. Clean, level, and prepare the floor for installation.

2. Determine the location of the drain pipe on the floor by taking

NOTE

· The uneven surface --- To finish polishing a bathtub, we usually apply wax to

make it shine and protect it from stains and scratches. However, the extra wax

will eventually generate uneven surface.Before using it, please use a clean cloth

with warm water in circular motions to lightly wipe the surface to remove the extra

wax.

· The water stain --- To finish testing the bathtub overflow, we usually inspect the

bathtub overflow drains by running water down the drains to test if there is any

leak at the over flow. Therefore, water strains may be found on the surface of the

bathtub.

PAGE 1
INSTALLATION MANUAL NOTE · The uneven surface --- To finish polishing a bathtub, we usually apply wax to make it shine and protect it from stains and scratches. However, the extra wax will eventually generate uneven surface.Before using it, please use a clean cloth with warm water in circular motions to lightly wipe the surface to remove the extra wax.
PAGE 2
4. After adjusting the balance of the bathtub with a level, use white/clear silicone around the tub base to complete installation. (figure 2) CLEANING AND MAINTENANCE 1. The bathtub is usually cleaned with general liquid detergent and soft cloth, can not use the detergent that contains acetone or ammonia water element. When you disinfect the bathtub, please use disinfectant without formaldehyde. 2. Surface stain can be rubbed with toothpaste on soft cloth. 3.