Workshop Manual
Table Of Contents
- COVER
- INTRODUCTION
- SAFETY
- CONTENTS
- SECTION 1 GENERAL
- SECTION 2 UPPERSTRUCTURE
- Cab
- Counterweight
- Main Frame
- Pump Device
- REMOVE AND INSTALL PUMP DEVICE
- DISASSEMBLE PUMP DEVICE
- ASSEMBLE PUMP DEVICE
- MAINTENANCE STANDARD
- ALLOWABLE LIMITS FOR CYLINDER BLOCK
- DISASSEMBLE REGULATOR
- ASSEMBLE REGULATOR
- DISASSEMBLE FAN PUMP
- ASSEMBLE FAN PUMP
- MAINTENANCE STANDARD
- DISASSEMBLE REGULATOR (FAN PUMP)
- ASSEMBLE REGULATOR (FAN PUMP)
- STRUCTURE OF PILOT PUMP
- Control Valve
- REMOVE AND INSTALL CONTROL VALVE
- DISASSEMBLE CONTROL VALVE (4-SPOOL HOUSING SIDE)
- ASSEMBLE CONTROL VALVE (4-SPOOL HOUSING SIDE)
- DISASSEMBLE CONTROL VALVE (5-SPOOL HOUSING SIDE)
- ASSEMBLE CONTROL VALVE (5-SPOOL HOUSING SIDE)
- DISASSEMBLE CONTROL VALVE (4-SPOOL HOUSING UPPER AND LOWER SURFACES)
- ASSEMBLE CONTROL VALVE (4-SPOOL HOUSING UPPER AND LOWER SURFACES)
- DISASSEMBLE CONTROL VALVE (5-SPOOL HOUSING UPPER AND LOWER SURFACES)
- ASSEMBLE CONTROL VALVE (5-SPOOL HOUSING UPPER AND LOWER SURFACES)
- DISASSEMBLE CONTROL VALVE (4-SPOOL CONTROL VALVE)
- ASSEMBLE CONTROL VALVE (4-SPOOL CONTROL VALVE)
- DISASSEMBLE CONTROL VALVE (5-SPOOL CONTROL VALVE)
- ASSEMBLE CONTROL VALVE (5-SPOOL CONTROL VALVE)
- DISASSEMBLE CONTROL VALVE (HOUSING FRONT AND REAR SURFACES)
- ASSEMBLE CONTROL VALVE (HOUSING FRONT AND REAR SURFACES)
- DISASSEMBLE HOUSING
- ASSEMBLE HOUSING
- Swing Device
- Pilot Valve
- Pilot Shut-Off Solenoid Valve
- Solenoid Valve
- Signal Control Valve
- Shockless Valve
- Fan Valve
- Fan Motor
- Engine
- SECTION 3 UNDERCARRIAGE
- SECTION 4 FRONT ATTACHMENT
- SERVICE MANUAL REVISION REQUEST FORM
SAFETY
SA-10
KEEP RIDERS OFF MACHINE
• Riders on machine are subject to injury such as be-
ing struck by foreign objects and being thrown off
the machine.
• Only the operator should be on the machine.
Keep riders off.
• Riders also obstruct the operator's view, resulting
in the machine being operated in an unsafe
manner.
014-E01B-0427
SA-379
PRECAUTIONS FOR OPERATIONS
• Investigate the work site before starting operations.
• Be sure to wear close fitting clothing and safety
equipment appropriate for the job, such as a hard
hat, etc. when operating the machine.
• Clear all persons and obstacles from area of op-
eration and machine movement.
Always beware of the surroundings while operat-
ing. When working in a small area surrounded by
obstacles, take care not to hit the upperstructure
against obstacles.
• When loading onto trucks, bring the bucket over
the truck beds from the rear side. Take care not to
swing the bucket over the cab or over any person.
M104-05-015