Fault Codes DTC & Troubleshooting

Table Of Contents
5 APPENDIX
- 365 -
5.1.7 Error messages from the J.NET SYSTEM
Error message Required action
No option module is mounted. Check if the J.NET or J.NET-INT module is installed properly.
The form of J.NET module is unknown. The J.NET or J.NET-INT module may be in a failure condition.
Replace the module.
Enter an address. Although the check box to indicate “addresses not used” is
deselected, no addresses were entered. Enter address values for
the NET1 and NET2 status table addresses.
No station type is selected. Select the desired value as the station type.
Duplicated station ID The specified station number is duplicated with another ID’s.
Set a non-duplicated station number.
The sum of input bytes and output bytes cannot
exceed /100.
Reduce the total number of input and output bytes to /100 or
less.
Neither input byte nor output byte may be 0. When the station type is AUTO, both the input byte and output
byte may not be set to 0. Set either the input or output byte to a
non-zero value.
The address is out of bounds.
Duplicated address
Incorrect address setting was made. Set the correct address
values.
Enter between xxbps to 19200bps The input value was out of the permitted range. Set the
transmission speed to a value in the range xx to 19200, or change
the set value of transmission delay time.
Enter 0 Please enter an integer between xxx and
xxx.
Enter a value of 0 or an integer in the range xx to 32767.
Sending failed The connection was terminated abruptly during data
communication. Check the connection status of the
communication line.
https://www.truck-manuals.net/