Manual

Turning DVD Video Camera/Recorder On and

Off

While holding down the gray button at the right

of power switch, set the switch according to

each recording function:

Set to "OFF":

Tile DVD video camera/

recorder will turn off

Set to "D":

To record still on SD

Illen/O rv card

Set to "411":

To record movie on DVD-

RAM/DVD-RW/DVD-R/

+RW disc

-Set to "1_1":

To record still on DVD-

RAM disc

Note:

• Once you turn the DVD video camera/recorder on to

let it recognize the disc, you can immediately record

or play back by turning the DVD video camera/

recorder on again. However, if a long time has

elapsed after the disc was inserted, it will take some

time for the DVD video camera/recorder to start

because it must recognize the disc again (see

"Troubleshooting" on page 135),

• It will take some time for the DVD video camera/

recorder to display the Disc Navigation screen after

power is turned on,

• When the DVD video camera/recorder is turned on,

the self-diagnosis function will work and a message

may appear. In this case, refer to "Trouble Messages"

on page 129 and take corrective action.

Power ON status

During playback, set the power switch to %1'

or "1_1"when using disc, or set it to "[i_ril"when

using card.

Turn the switch while

holding down the gray

button at the right of switch,

Power switch