User Guide



Command Control via the Network

<RXFDQFRQ¿JXUHDQGFRQWUROWKHSURMHFWRUYLDWKHQHWZRUNXVLQJ56&

commands.

Communication Port

The following two ports are assigned for the command control.

7&3

7&3

Command Control Settings

&RQ¿JXUHWKHIROORZLQJLWHPVIURPDZHEEURZVHUZKHQFRPPDQGFRQWUROLVXVHG

Example: If the IP address of the projector is set to 192.168.1.10:

• Command control is not available via communication port (TCP

WKDWLVXVHGIRUWKHH6+27WUDQVPLVVLRQIXQFWLRQ

NOTE

1) Enter [https://192.168.1.10] into the address bar of the web browser.

2) Enter the Administrator ID and Password and click [Logon].

&OLFN[Port settings] on the main menu.

4) Click the [Enable] check box to open >1HWZRUN&RQWURO3RUW3RUW@ to use

7&3&OLFNWKH[Enable] check box for the [Authentication] setting when

authentication is required, otherwise clear the check box.

&OLFNWKH[Enable] check box to open >1HWZRUN&RQWURO3RUW3RUW@ to

XVH7&3&OLFNWKH[Enable] check box for the [Authentication] setting

when authentication is required, otherwise clear the check box.

&OLFNWKH[Apply] button to save the settings.

(

