Operation Manual
6
Installation
NOTE
• Set the tilt angle of Set A to within 9 degrees from the level line.
(continued on next page)
Deciding installation position
Decide the position of Set A and its projection angle. (User’s Manual (concise)
→
Arrangement and Adjusting the projector’s elevator)
2.2 Installing the first projector (Set A)
Setting up Set A
2. Perform the INSTALLATION setting rst if necessary as it may change the
image position. (Operating Guide → SETUP menu )
3. Adjust the image of Set A to t the screen with the ZOOM, FOCUS and LENS
SHIFT features. (Operating Guide → Adjusting the lens)
Adjust the image position using KEYSTONE and PERFECT FIT if necessary.
(
Operating Guide → EASY MENU or SETUP menu)
NOTE • KEYSTONE cannot be operated when PERFECT FIT is in use.
To adjust the image using both KEYSTONE and PERFECT FIT, adjust
KEYSTONE rst.
• If you are using Simple Stack, go to
2.3 Installation of the second projector
(Set B). (
8
)
1. Turn on Set A.
WARNING ►
Only for &3;, &3:; and &3:8, it is possible
to install the projector for any direction with specied mounting accessories.
Consult with your dealer about such a special installation.