User Guide

16
ENGLISH
You will use the power button located at the lower right side of the front panel of your
display to turn on and off the display.
The functions of the three control buttons, which are located at the lower middle-left side of
the front panel of your display, are described as below:
Button Function Description
Select
(1) Bring-up OSD Main Menu.
(2) Select item for user adjustment.
Right ( )
(1) Item selection move upward or user-adjustable value
increasing (in main menu).
(2) Bring-up Audio/Video Menu (Direct-key function).
Left ( )
(1) Item selection move downward, user-adjustable value
decreasing (in Main Menu) .
(2) Auto Setup (Direct-key function, Analog input signal only).
Making the Connections
Before connecting any cables, make sure that the computer and display are turn off.
To connect the power and video signal cables:
1. Locate the AC power adapter with attached power cable.
2. Connect the power cable to the power jack on the back of the display (“DC IN” as shown
below).
3. Plug the three-prong power cord into a power outlet, and plug the other end into the AC
power adapter.
4. Plug the speaker audio cable(black) into “AUDIO OUT” port and then plug the red side
into right speaker box , the white side into left speaker box.
When using with a PC:
5. Plug the analog (or digital) video signal cable into the Analog (or Digital) Video Input
port on the back of the display (“ANALOG IN” (or “DIGITAL IN”) as shown above).
6. Connect the other end of the video cable into your computer’s video port. (Please check
your computer’s documentation if you’re not sure where the port is located.)
7. Connect the audio-mic cable (green) from “AUDIO IN” port of the display to the line-out
port of your PC and connect other wire (red) from “MIC” port of the display to the line-in
port of your PC.