User Guide

A BE CAREFUL OF GENERATED MAGNETISM!
After the power has been turned on or the “DEGAUSS” button has been pressed, the
E
H
CRT is demagnetized for approximately 10 seconds. This generates a strong magnetic F
field around the front cover which may affect the data stored on magnetic tape or disks ~
near the front cover. Place such magnetic recording equipment and tapes/disks apart ~
from this unit.
E
.
~ AVOID FREQUENT POWER ON-OFF SWITCHING!
DO NOT repeat OFF and ON in a short period. It may cause blurred colours or
distortion of the displayed pattern.
4J REMOVE THE POWER CORD FOR COMPLETE SEPARATION!
For complete separation from the power source, remove the power cord from the
monitor or from the wall outlet.
~ AMBlENT ILLUMINATION
Avoid direct rays of the sun or room lighting onto the CRT screen in order to prevent
eye fatigue.
~ ABOUT CLEANING
This monitor has a non-glare and anti-electrostatic treatment on the surface of the
screen. Use water or an alcoholic solvent with a soft cloth like gauze to clean the
surface of the screen. NEVER use an abrasive, glass cleaner containing highly
concentrated ammonia and strong base chemicals since they damage the surface
treatment.
Clean the cabinet and controls with a lightly moistened soft cloth.
DO NOT use aerosol sprays, solvents or abrasive clearners.
~ BE CAREFUL OF POWER CORD CONNECTION
Before inserting the plug of the power cord into a receptacle of the correct voltage,
check that the connection portion of power cord is clean (with no dust). Then, insert the
plug of power cord to a receptacle firmly, otherwise it may cause electrical shock or fire.
A CAUTION for 200- 240V operation only
This equipment relies on the protective devices in the building installation for short-
circuit and over-current protection. Refer to the following table for the suitable number
and location of the protective devices which should be provided in the building
installation.
Protective devices in single-phase equipment or sub-assemblies
Protection
Minimum number Location
against
of fuses or circuit-
breaker poles
Equipment to be connected to
Earth faults 1 Both conductors
POWER SYSTEMS with earthed
Overcurrent 1 Either of the two
neutral reliably identified
conductors
Equipment to be connected to
Earth faults 2 Both conductors
any supply, including IT POWER
Overcurrent
1
SYSTEMS and supplies with
Either of the two
conductors
reversible duas
Verify that the protective devices in the building installation meets the conditions in the
table prior to installing the equipment.
3