Owner's Manual

USING THE REMOTE TO CONTROL

SET-TOP-BOX/SATELLITE RECEIVER FUNCTIONS

Operating the precoded function for your set-top-box/satellite receiver.

This remote is designed to operate different types of set-top-box/satellite systems. You must first program the remote to match the

remote system of your set-top-box/satellite systems (refer to pages 38-39 for pre-codes).

1. Turn ON your set-top-box/satellite systems.

2. Aim the remote control at the front of your set-top-box/satellite systems.

3. To switch to set-top-box/satellite (STB) pre-coded mode, use the SOURCE ACCESS buttons ( , ) on the remote control to posi-

tion the LED light to the corresponding selection.

4. Hold down the ENT button on the remote and enter the four digit preset code that matches your set-top-box/satellite receiver as

shown on page 38-39. Release the ENT button. The indicator light will flash 3 times if the code was accepted.

5. Aim the remote at the set-top-box/satellite receiver and press the POWER button. The remote will turn off your set-top-box/satel-

lite receiver when the correct four digit preset code is entered. When this occurs, the remote control is programmed for your set-

top-box/satellite receiver. If the set-top-box/satellite receiver does not turn off, try a different four digit preset code.

6. The remote will now control your set-top-box/satellite receiver.

NOTES:

1. If your set-top-box/satellite receiver cannot be operated

after performing the above procedures, your set-top-

box/satellite receiver code has not been precoded into the

remote.

2. In the unlikely event that your set-top-box/satellite

receiver cannot be operated after performing the above

procedures, please consult your set-top-box/satellite

receiver operating guide.

3. The remote control will remember the codes you have

programmed until the batteries are removed from the

remote control. After replacing the batteries repeat the

entire programming procedure as stated above.

 PRE-CODED SET-TOP-BOX/SATELLITE RECEIVER

buttons

These buttons transmit the chosen pre-coded set-top-

box/satellite codes.

 EXCLUSIVE TV buttons

These buttons are for operating the TV.

GUIDE











C.C.



MY SATELLITE RECEIVER/STB CODE IS:

NOTE: Refer to instruction manual of the set-top-box/satellite receiver for operation of the buttons exclusively for the set-top-

box/satellite receiver.

THE REMOTE CONTROL