User Manual

52
Enabling Live TV Pause
You can start setting up Live TV Pause in any of the following ways:
 Go to Settings > TV inputs > Antenna TV > Live TV Pause, and then select Enable.
 After completing a channel scan, select Set up Live TV Pause from the available
options.
 Press Play/Pause on the Roku remote while watching a digital Antenna TV channel.
 Highlight the Antenna TV tile on the Home screen, press  on the remote, and then
select Enable Live TV Pause.
After starting setup of Live TV Pause in any of these ways, the TV prompts you through the
steps needed to enable this feature. Setup takes only a few moments.
Note: Use of a USB hub is not supported.
Using Live TV Pause
If you have used the Roku remote to watch streaming channels, using Live TV Pause should be
very familiar to you.
 While watching a digital Antenna TV channel, press PLAY/PAUSE to pause or play the
content. After the TV program has been paused for 90 minutes, the TV resumes playing.
 After watching a channel for a while, press REWIND to jump back up to the point where
you first started watching the channel, up to 90 minutes.
 After pausing or rewinding, press FAST FORWARD to jump ahead up to the point where
you are once again watching the live TV program.
 Press FAST FORWARD or REWIND repeatedly to cycle through 1x, 2x, and 3x skip
speeds. Press INSTANT REPLAY to play back the last several seconds of the
program.
 When the program is paused, press the LEFT and RIGHT arrows to move forward and
backward through the program approximately 10 seconds per press. Small frames
appear across the screen to identify your location in the program.