Installation Guide

H I N K L E Y L I G H T I N G 12600 Berea Road Cleveland, OH 44111 800.446.5539 / 216.671.3300 www.hinkleylighting.com

assembly instructions

Family: Alice Item No. 5834

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

*** The construction of this ﬁxture will be accomplished by ﬁrst attaching the

mounting strap to the junction box, making all necessary electrical connections,

assembling the main body of the ﬁxture, mounting the ﬁxture to the wall,

and then installing the glass.

start here

5834

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 2 - Glass Installation

Make electrical connections from supply wire to ﬁxture lead wires. Refer to instruction

sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.

Then refer back to this sheet to continue installation of this ﬁxture.

1. Remove main mounting plate (A) from ﬁxture back plate (B) by removing the four

ﬂat head screws (C) - see Drawing 1.

2. Slide the wires from the junction box, through the large center hole, making sure

curved slots (D) line up with the threaded holes (E) in the junction box.

3. Using two 8-32 screws (F) attach the main mounting plate (A) to the junction box,

making sure top of mounting plate (A) is parallel to ceiling.

1. Mount the ﬁxture by sliding the back plate (B) over mounting plate (A) - see

Drawing 1.

2. Attach the back plate (B) to the mounting plate using the screws (F).

Drawing 1 - Fixture Mounting

BC C

Note: Maximum wattage for 5834 ﬁxture is 100 watts per bulb.

2. To install glass, remove the socket ring (3) and spacer (4) from the socket (5) - see

Drawing 2.

3. Place glass (6) over the socket (5).

4. Slip spacer (4) over socket and then thread socket ring (3) back on to socket (5) and

5. Fixture can now be lamped accordingly.

10.19.10

1. Prior to installing glass thread ﬁnial (1) into arm (2).

use socket tool provided to tighten. Note: Over tightening could cause damage to glass.

socket tool