Operating Instruction DG 150
Manuals
Brands
Hilti Manuals
Grinders & Sanders
DG 150 Concrete grinder
9
10
11
12
13
14
15
16
17
18
Table Of Contents
Original operating instructions
1 Information about the documentation
1.1 About this documentation
1.2 Explanation of symbols used
1.2.1 Warnings
1.2.2 Symbols
1.2.3 Illustrations
1.3 Product information
1.4 Declaration of conformity
2 Safety
2.1 Safety instructions
2.1.1 General power tool safety warnings
2.1.2 Safety warnings common for grinding, sanding, wire brushing, polishing or abrasive cutting-off operations:
2.1.3 Additional safety instructions
3 Description
3.1 Product overview
3.2 Tool components and controls
3.3 Tool components, status indicators and controls
3.4 Intended use
3.5 Possible misuse
3.6 Items supplied
4 Technical data
4.1 Technical data, DG 150
4.2 Technical data, DPC 20
5 Operation
5.1 Preparations at the workplace
5.1.1 Adjusting the guard
5.1.2 Adjusting the guard for working close to an edge
5.1.3 Adjusting the side handle
5.1.4 Fitting a diamond cup wheel
5.1.5 Removing the diamond cup wheel
5.2 Types of work
5.2.1 Setting the speed of the diamond cup wheel
5.2.2 Switching on
5.2.3 Trying out after fitting a new diamond cup wheel
5.2.4 Grinding
5.2.5 Switching off
6 Care of the product
6.1 Removing the guard lamellar seal
6.2 Installing the guard lamellar seal
7 Troubleshooting
7.1 DG 150
7.2 DPC 20
7.3 Unlisted fault
8 Disposal
9 Manufacturer’s warranty
Hilti
=
registered
trademark
of
Hilti
Corp.,
Schaan
**
20171011
Printed: 20.11.2017 | Doc-Nr: PUB / 5385705 / 000 / 01
1
...
...
16
17
18