Operating instructions

620-690nm/0.95mW max.
CLASS II LASER PRODUCT
LASER RADIATION - DO NOT
STARE INTO BEAM
CAUTION
On the tool
Do not stare into the beam.
Laser warning plates for the USA in accordance with CFR
21§1040(FDA).
On the tool
Laser Class 2 in accordance with IEC/EN 60825‑1:2007
Location of identification data on the tool
The type designation and serial number can be found on
thetypeidentificationplateonthetool.Makeanoteof
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
2 Description
2.1 Use of the product as directed
The PMC 46 is a self-leveling combilaser which allows a single person to level, plumb, align and transfer right angles
quickly and accurately. The tool projects two lines (horizontal and vertical) and five points (above, below, right, left
and line intersection). The lines and line intersection point have a range of approx. 10m. All other points have a range
of approx. 30m. Range depends on the brightness of ambient light.
The tool is designed mainly for indoor use and is no substitute for a rotatinglaser.
When used for outdoor applications, care must be taken to ensure that the general conditions are similar to those
encountered indoors. Possible applications are:
Marking the position of partition walls (at right angles and in the verticalplane).
Aligning components to be installed or sections of a structure in three axes.
Checking and transferring right angles.
Transferring measuring marks from the floor to the ceiling.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
2.2 Features
The PMC 46 levels itself automatically within a range of approx. 5°.
Self-leveling takes only approx. 3 seconds.
The combilaser gives an “Out of self-leveling range” warning when the self-leveling range is exceeded (the laser beams
blink).
The PMC 46 is characterized by its ease of operation and use, its rugged plastic casing and ease of transport due to
its compact dimensions and light weight.
The tool can be used together with the PMA 31 laser receiver.
In the normal operating mode, the tool switches itself off after 15 minutes. Sustained operating mode can be activated
by pressing and holding the on-switch for four seconds.
2.3 Items supplied with the cardboard box version
1 Combilaser
1 Soft pouch
4Batteries
1 Operating instructions
1 Manufacturer’s certificate
en
12
Printed: 11.04.2016 | Doc-Nr: PUB / 5071418 / 000 / 03