Use and Care Manual

7
7 Transport and storage of cordless tools
Transport
CAUTION
Inadvertent starting during transport. Uncontrolled starting during transport may occur if the battery
is fitted, thereby resulting in damage to the tool.
▶ Always remove the battery before transporting the tool.
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Inadvertent damage caused by defective battery. A leaking battery may damage the tool.
▶ Always remove the battery before storing the tool.
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 The metal construction screwdriver is not operational.
Trouble or fault Possible cause Action to be taken
The metal construction
screwdriver doesn’t start.
The battery is not fully inserted. ▶ Push the battery in until it
engages with an audible click.
The battery is discharged. ▶ Charge the battery.
Electrical fault. ▶ Switch the metal construction
screwdriver off immediately,
remove the battery, keep it
under observation, allow it
to cool down and contact
HiltiService.
The control switch can’t be
pressed, i.e. the switch is
locked.
The forward / reverse switch is in
the middle position.
▶ Push the forward / reverse
switch to the left or right.
The battery is not heard to
engage.
The retaining lugs on the battery
are dirty.
▶ Clean the retaining lugs and
push the battery in until it
engages. Contact Hilti Service
if the problem persists.
LED 1 blinks. The battery is discharged. ▶ Charge the battery.
The battery is too hot. ▶ Bring the battery to the recom-
mended operating temperature.
The battery is too cold. ▶ Bring the battery to the recom-
mended operating temperature.
The screwdriver doesn’t work
and all four LEDs blink.
The product is overloaded (appli-
cation limits exceeded).
▶ Release the control switch and
then press it again. Reduce the
load on the tool.
Printed: 27.07.2016 | Doc-Nr: PUB / 5293039 / 000 / 00