Operating Instruction AG 500-11S (05)

2 English
This symbol is intended to draw special attention to certain points
when handling the product.
Wireless data transfer
1.3 Product-dependent symbols
1.3.1 Symbols on the product
The following symbols are used on the product:
Wear eye protection.
Revolutions per minute
Revolutions per minute
Rated speed
Diameter
Protection class II (double-insulated)
1.4 Product information
Hilti products are designed for professional use and may be operated, ser-
viced and maintained only by trained, authorized personnel. This personnel
must be informed of any particular hazards that may be encountered. The
product described and its ancillary equipment may present hazards when
used incorrectly by untrained personnel or when used not as directed.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. Always quote this
information when you contact a Hilti representative or Hilti Service to
enquire about the product.
Product information → page 2
Product information
Angle grinder AG 500-11S
Generation 05
Serial no.
1.5 Declaration of conformity
We declare, on our sole responsibility, that the product described here
complies with the applicable directives and standards. A copy of the
declaration issued by the certification department can be found at the end
of this documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916
Kaufering, Germany
Printed: 19.10.2018 | Doc-Nr: PUB / 5402264 / 000 / 01