Operating Instruction DC-D, DG-CW, DC-TP
3
Diamond Blades/Wheels en
This cutting disc/grinding wheel (referred to as the “accessory”) is intended for use
with a hand-held grinder (referred to as the “tool”).
The speed (RPM) listed on the accessory must be
higher than the speed of the tool. If in doubt, the ma-
ximum peripheral speed of an accessory is 80 m/s.
Clean thespindle,ange and clamping nut before
mounting the accessory. Use the correct mounting
anges, nut, and guard recommended in the tool
operator’s manual. Position the guard so the ma-
ximum area of protection is between you and the
accessory.
The operator and bystanders must always wear
approved safety goggles/glasses, protective gloves,
ear protectors and protective clothing.