Operating Instruction SF 6(H)-22 (03)

10 English 2275218
*2275218*
6 Operation
CAUTION
Risk of injury if the accessory tool stalls !
▶ Check that the side handle is fitted correctly and tightened securely. Always hold the tool with both
hands on the grips provided.
▶ Wear eye protection to prevent splintering material from injuring your eyes.
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Selecting the gear 4
▶ Select the gear.
6.2 Setting forward or reverse rotation 5
▶ Set the forward/reverse switch to forward or reverse rotation, as applicable.
6.3 Switching on
▶ Press the control switch.
▶ The product starts.
Speed can be controlled steplessly by varying how far the control switch is pressed in.
6.4 Screwdriving 6
▶ Set the torque and operating mode selector ring to the required torque.
6.5 Drilling 6
▶
Set the torque and operating mode selector ring to .
6.6 Hammer-action drilling 6
▶
Set the torque and operating mode selector ring to .
6.7 Switching off
▶ Release the control switch.
▶ The product switches off.
7 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
Care of the Liion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
• Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.