Use and Care Manual

6 English 2253584
*2253584*
4 Technical data
Rated voltage
21.6 V
Stroke rate at idle speed
1,185 /min … 2,680 /min
Weight including battery B22⁄8.0
3.3 kg
(7.3 lb)
Ambient temperature for operation
−17 ℃ … 60 ℃
(1 ℉ … 140 ℉)
Storage temperature
−20 ℃ … 70 ℃
(−4 ℉ … 158 ℉)
4.1 Battery
Battery operating voltage
21.6 V
Ambient temperature for operation
−17 ℃ … 60 ℃
(1 ℉ … 140 ℉)
Storage temperature
−20 ℃ … 40 ℃
(−4 ℉ … 104 ℉)
Battery charging starting temperature
−10 ℃ … 45 ℃
(14 ℉ … 113 ℉)
4.2 Blade
Blades of different types are needed, depending on the thickness or strength of the material to be cut. Select
the correct blade for the purpose from the table below.
The blades have two cutting edges. The cutting edges cannot be resharpened.
Initial equipment, as supplied ex works: SSHCS 1.5  2.5 mm
SSHCS,
0.5  1.5 mm,
, for
straight cuts
SSHCS,
1.5  2.5 mm,
, for
straight cuts
SSHCX,
0.5  1.5 mm,
, for
straight cuts
in stainless
steel
SSHCC,
0.5  1.5 mm,
, for curves
SSHCD,
4 x 0.9 mm,
, for spiral
ducting
Permissible steel
thickness, steel
up to 400 N⁄mm²
1.5 mm
(0.06 in) 16 ga
2.5 mm
(0.10 in) 13 ga
•/• 1.5 mm
(0.06 in) 16 ga
•/•
Permissible steel
thickness, steel
up to 600 N⁄mm²
1.0 mm
(0.04 in) 20 ga
•/• 1.5 mm
(0.06 in) 16 ga
0.8 mm
(0.03 in) 22 ga
•/•
Permissible ma-
terial thickness,
aluminum up to
250 N⁄mm²
2.0 mm
(0.08 in) 12 ga
3.0 mm
(0.12 in) 9 ga
•/• 2.0 mm
(0.08 in) 12 ga
•/•
Permissible
material
thickness, steel
spiral ducting up
to 400 N⁄mm²
•/• •/• •/• •/• 4 x 0.9 mm
(4 x 0.035 in)
4 x 20 ga
Permissible
material
thickness, steel
spiral ducting up
to 600 N⁄mm²
•/• •/• •/• •/• 4 x 0.6 mm
(4 x 0.024 in)
4 x 24 ga