Operating Instruction DX 5 GR (01)
Table Of Contents
- Original operating instructions
- 1 Information about the documentation
- 2 Safety
- 3 Description
- 4 Technical data
- 5 Operation
- 5.1 Safety devices
- 5.2 Loading the single-fastener tool
- 5.3 Setting the power level
- 5.4 Driving fasteners with the single-fastener tool
- 5.5 Unloading the single-fastener tool
- 5.6 Switching Bluetooth on and off
- 5.7 Resetting the cleaning indicator
- 5.8 X-FCM grating fastener
- 5.9 X-FCP checker plate fastener
- 5.10 Driving X-GR grating fasteners
- 5.11 Procedure if a cartridge fails to fire
- 5.12 Tool misfires (cartridge doesn't fire)
- 6 Care and maintenance
- 7 Troubleshooting
- 8 Disposal
- 9 Manufacturer’s warranty
- 10 Confirmation of C.I.P. testing
10 English
5.4 Driving fasteners with the single-fastener tool
1. Position the tool.
2. Hold the tool perpendicular to the working surface and then press it against the surface.
3. Press the trigger to drive the fastener.
5.5 Unloading the single-fastener tool
1. Pull the cartridge out of the tool.
2. Pull the fastener out of the tool.
5.6 Switching Bluetooth on and off
▶ Press and hold the pushbutton for 1-2 seconds to switch on Bluetooth.
Bluetooth switches itself off automatically after 2 minutes.
5.7 Resetting the cleaning indicator
▶ Press and hold the pushbutton for 10-12 seconds to reset the cleaning indicator.
The cleaning indicator consists of 5 bars. Each bar stands for 500 fastenings.
Printed: 02.08.2018 | Doc-Nr: PUB / 5292636 / 000 / 02