WSR 1000 Reciprocating saw /I is essential thattheoperatinginstructions are read before the power toof is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are with thepower tool when it is given to other persons. CD o (}) ® ~ @®®® Contents 1. General information 2. Description ® (2) Page 1 2 3. Accessories 3 4. Technical data 5. Safety rules 6. Before use 7. Operation 4 4 7 8 8.
Symbol s V au Volts A Hz <: Am" ",'" Alternating nO /min Nominal stroke rate under no load Strokesper minute e Read tile operating current loc ation of identification data onthe power tool The type designationand serial number can be found onthetype identificationplateonthemachineor tool. Make a noteof this data in your operatinginstructions and always refer to it when making anenquiry to your Hilti representativeor service department.
, Technical data Right of techn ical changes reserved. III Power tool WSR 1000 Rated voltage Rated current input Mains fre quency Weight of power tool Dimensions (L x W x H) 120 V 9A 60 Hz 3.3 kg (7.28 Ib) 452 mm (17.8 in) x 97 mm (3.82 in) x 170 mm 16.69 in) 0... 2,800/ min. 28 mm (lYe') Keyless, tor W standard blades Electrical protection class II (double insulated) Stroke rate Stroke Blad e holder Protection class 5. Safet rules 5.
I) WARNING: Some dust created bygrinding , sand· ing, cutting and drilling contains chemicals known to cause cancer, birth defects, infertilit y or other reproductive harm; or serious and permanent respiratory or other injury. Some examples of these chemicals are: lead from lead-based paints, crystallinesilica from bricks, concrete and other masonry produ cts and natural stone, arsenic an d chromi um from chemically-treated lumber.
7. a eralion e a NOTE To ens ure good cutting performance and minimize stress on the power tool, use only saw blades that are in good condition. CAUTION Do not overload the power tool. It will work more efficiently and more safely within its intended per- formance range . 7.1 Safe operation I;) f.i CAUTION The power tool must be pressed against the workpiece until the contact shoe make s firm contact. This helps ensure maximum safety and good pe rformance.
Fault Possible cause Remedy The supply cord or plug is defective. Have it checke d by a trained electrical specialist and replaced it necessary. Have it checked by a trai ned The control switch is defective. electrical specialist and replaced if necessary. The powertool doesn't achieve The extension cord is toolong or its Use an extension cord of an tull powe r. gaugeis inadequate. approved length and I or of adequate gauge. The control switch is not pressed Press the control switch as far as it fully.