User's Manual

By default, all card readers of the added access control devices are set as start/end-work check
points. If you need to edit check point funcon of card reader(s), you can perform the following
operaons.
Steps
1.
En
ter the Time & Aendance module.
2.
Click Aendance
Sengs → Aendance Check Point to enter the aendance check point
sengs page.
3.
Set Set All Card Readers as Check Points switch to o.
4.
Check the desired card reader(s) as aendance check point(s) in the list below.
5.
Set check point funcon as Start/End-Work, Start-Work or End-Work.
Note
When
selecng Start-Work or End-Work, the aendance status uploaded from the device will
be decided by the check point funcon you set here.
Start-Work
Aendance status uploaded from the device will all be calculated as Check-in.
End-W
ork
Aendance status uploaded from the device will all be calculated as Check-out.
Start/End-Work
Aendance status will be calculated as Check in/out according to the actual aendance
status on the device.
6.
Click Se
t as Check Point.
The congured
aendance check point(s) are displayed on the right list.
7.
Oponal: Aer seng aendance check points, and perform the following operaons.
Edit Check
P
oint
Check one aendance check point, click Edit to edit its informaon including
name, check point funcon, etc.
Check two or more aendance check points, click Edit to batch edit check
point funcon, enter remark, etc.
Delete Check
P
oint
Check one or more check points, and click Delete to delete it/them.
Congure Holiday
You can add the holiday during which the check-in or check-out will not be recorded.
DS-K5671B Series Face Recognion Terminal User Manual
190