User's Manual

Note
N1 refers to wired network.
Set ISUP Parameters
Set the ISUP parameters for accessing device via ISUP protocol.
St
eps
Note
The
funcon should be supported by the device.
1.
Click Conguraon → Ne
twork → Advanced Sengs → Plaorm .
2.
Select ISUP from the plaorm access mode drop-down list.
3.
Check Enable.
4.
Set the ISUP version, and view the alarm receiver type, server address, port, device ID, register
status.
Note
If you select 5.0 as the version, you should set the ISUP key as well.
5.
Se
t the ISUP listening parameters, including ISUP alarm center IP address/domain name, ISUP
alarm center URL, and ISUP alarm center port.
6.
Click Save.
Plaorm Access
Plaorm access provides you an opon to manage the devices via plaorm.
Steps
1.
Click Conguraon → Ne
twork → Advanced → Plaorm Access to enter the sengs page.
2.
Select the Plaorm Access Mode.
Note
Hik-Connect is an applicaon for mobile devices. With the App, you can view live image of the
de
vice, receive alarm nocaon and so on.
3.
Check the checkbo
x of Enable to enable the funcon.
4.
Oponal: Check the checkbox of Custom, and you can set the server address by yourself.
5.
Create a Stream
Encrypon/Encrypon Key for the device.
Note
6 to 12
leers (a to z, A to Z) or numbers (0 to 9), case sensive. You are recommended to use a
combinaon of no less than 8 leers or numbers.
DS-K5671B Series Face Recognion Terminal User Manual
100