User's Manual

Table Of Contents
Figure 8-7 Wi-Fi Sengs Page
2.
Check Wi-Fi.
3.
Select a Wi-Fi
-
Click of a Wi-Fi in the list and enter the Wi-Fi password.
-
Click Add, and en
ter the SSID, working mode, and encrypon type. Click Connect. When the
Wi-Fi is connected, click OK.
4.
Oponal: Se
t the WLAN parameters.
1) Click Network Sengs.
2) Set the IP address, subnet mask, and default gateway. Or check Enable DHCP and the system
will allocate the IP address, subnet mask, and default gateway automacally.
5.
Click OK.
Report Strategy Sengs
You can set the center group for uploading the log via the ISUP protocol.
Go t
o Conguraon → Network → Basic Sengs → Report Strategy .
You can set the center group and the system will transfer logs via ISUP protocol. Click Save to save
the sengs.
Center Group
Select a cen
ter group from the drop-down list.
Enable Main Channel
Click to Enable main channel sengs.
Main Channel
Click Enable, and the device will communicate with the center via the main channel.
DS-K5671B Series Face Recognion Terminal User Manual
99