User's Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Model
- Chapter 1 Overview
- Chapter 2 Appearance
- Chapter 3 Installation
- Chapter 4 Wiring
- Chapter 5 Activation
- Chapter 6 Quick Operation
- Chapter 7 Basic Operation
- Chapter 8 Operation via Web Browser
- 8.1 Login
- 8.2 Person Management
- 8.3 Configuration
- 8.3.1 View Device Information
- 8.3.2 Set Time
- 8.3.3 Set DST
- 8.3.4 View Open Source Software License
- 8.3.5 Upgrade and Maintenance
- 8.3.6 Security Mode Settings
- 8.3.7 Change Administrator's Password
- 8.3.8 View Device Arming/Disarming Information
- 8.3.9 Network Settings
- 8.3.10 Set Audio Parameters
- 8.3.11 Set Image Parameters
- 8.3.12 Set Authentication Parameters
- 8.3.13 Temperature Measurement Settings
- 8.3.14 Set Biometric Parameters
- 8.3.15 Visitor Settings
- 8.3.16 Set Screen Saver Picture
- Appendix A. Tips When Collecting/Comparing Face Picture
- Appendix B. Tips for Installation Environment
- Appendix C. Dimension
- Appendix D. Communication Matrix and Device Command
Figure 6-3 Select Network
Wired Network
Note
Make sure the device has connected to a network.
If enable DHCP, the system will assign the IP address and other parameters automacally.
If disable DHCP, you should set the IP address, the subnet mask, and the gateway.
Wi-Fi
Select a Wi-Fi and enter the Wi-Fi's password to get connected.
Or tap Add Wi-Fi and enter the Wi-Fi's name and the password to get connected.
Note
Disconnect the wired network before connecng a Wi-Fi.
2.
Tap Next.
3.
Oponal: Tap Skip to skip network sengs.
4.
Oponal: Tap PREVIOUS to back to the previous page.
DS-K5032-3XFD Visitor Terminal User Manual
12