User's Manual

Table 6-2 Access Control Parameters Descripons
Parameter Descripon
Terminal Auth. Mode (Terminal
Authencaon Mode)
Select the face recognion terminal's authencaon mode. You
can also customize the authencaon mode.
Note
• Only the device with the ngerprint module supports the
ngerprint related funcon.
• Biometric recognion products are not 100% applicable to
an-spoong environments. If you require a higher security
le
vel, use mulple
authencaon modes.
• If you adopt mulple authencaon modes, you should
authencate other methods before authencang face.
Reader Auth. Mode (Card
Reader Authencaon Mode)
Select the card reader's authencaon mode.
NFC An-Cloning Enable the funcon and you cannot use the cloned card for
authencaon.
Door Contact You can select "Open (Remain Open)" or "Close (Remian
Closed)" according to your actual needs. By default, it is Close
(Remian Closed).
Door Open Time Set the door unlocking duraon. If the door is not opened for
the set me, the door will be locked. Available door locked me
range: 1 to 255s.
6.11 Time and Aendance Status Sengs
Set
me and aendance status. You can set the aendance mode as check in, check out, break
out, break in, overme in, and over according to your actual situaon.
Note
The
funcon should be used cooperavely with me and aendance funcon on the client
soware.
6.11.1 Disable Aendance Mode via Device
Disable the aendance mode and the system will not display the aendance status on the inial
page.
T
ap T&A Status to enter the T&A Status page.
DS-K1T642 Series Face
Recognion Terminal User Manual
35