EPI-4225I-DE-Quick-start-Guide

QSG EPI-4225I-DE 030518NA 5
 Input voltage should meet both the SELV (Safety Extra Low Voltage) and the Limited
Power Source with 24 VAC or 12 VDC according to the IEC60950-1 standard. Refer to
technical specifications for detailed information.
 Do not connect several devices to one power adapter as adapter overload may cause
over-heating or a fire hazard.
 Make sure that the plug is firmly connected to the power socket.
 Make sure that the power has been disconnected before you wire, install or
dismantle the speed dome.
 When the product is mounted on wall or ceiling, the device shall be firmly fixed.
 If smoke, odor or noise rise from the device, turn off the power at once and unplug
the power cable, and then contact the service center.
 If the product does not work properly, contact your dealer or the nearest service
center. Never attempt to disassemble the speed dome yourself. (We shall not assume
any responsibility for problems caused by unauthorized repair or maintenance.)
Cautions
 If the speed dome fails to synchronize local time with that of the network, you need
to set up speed dome time manually. Visit the speed dome (via web browser or client
software) and enter system settings interface for time settings.
 Make sure the power supply voltage is correct before using the speed dome.
 Do not drop the speed dome or subject it to physical shock, and do not expose it to
high electromagnetism radiation. Avoid installation on vibrations surface or places
subject to shock (ignorance can cause device damage).
 Do not touch senor modules with fingers. If cleaning is necessary, use clean cloth with
a bit of ethanol and wipe it gently. If the speed dome will not be used for an extended
period, replace the lens cap to protect the sensor from dirt.
 Do not aim the speed dome at the sun or extra bright places. Blooming or smearing
may occur otherwise (which is not a malfunction), and affect the endurance of sensor
at the same time.
 The sensor may be burned out by a laser beam, so when any laser equipment is in
using, make sure that the surface of sensor will not be exposed to the laser beam.
 Do not place the speed dome in extremely hot, cold, dusty or damp locations, and do
not expose it to high electromagnetic radiation.
 To avoid heat accumulation, good ventilation is required for operating environment.
 Keep the speed dome away from liquid while in use.
 While in delivery, the speed dome shall be packed in its original packing, or packing of
the same texture.
 Improper use or replacement of the battery may result in hazard of explosion.
Replace with the same or equivalent type only. Dispose of used batteries according to
the instructions provided by the battery manufacturer.