User Manual

UM DS-90xxHUHI-F8/N User Manual 041717NA 43
4. Select the parameters of the PTZ camera from the drop-down list.
NOTE: All the parameters should be exactly the same as the PTZ camera
parameters.
For a connected Coaxitron camera/dome, select the HIKVISION-C
PTZ protocol. Make sure the protocol selected here is supported by
the connected camera/dome.
If HIKVISION-C protocol is selected, all other parameters such as
baud rate, data bit, stop bit, parity, and flow control are not
configurable.
5. (Optional) Click Copy button to copy the settings to
the other channels. Select the channels you want to
copy to and click OK to return to the PTZ Parameters Settings interface.
Figure 55, Copy to Other Channels
6. Click OK to save the settings.
7. (Optional) Check the Enable Omnicast Control checkbox to enable the PTZ control of the selected
camera via Omnicast VMS of Genetec.
10.2. Setting PTZ Presets, Patrols, and Patterns
10.2.1. Before Starting
Please make sure that the presets, patrols, and patterns are supportsed by PTZ protocols.
10.2.2. Customizing Presets
Follow the steps to set the Preset location which you want the PTZ camera to point to when an
event takes place.
1. Enter the PTZ Settings interface, Menu > Camera > PTZ.