Assembly Instructions

!
Step One
Use the provided tool to remove packing blocks. Packing
blocks are there to protect the table during shipping and are no
longer needed.!
!
Table Assembly Instructions!
Step Two
Place provided dowel pins in the holes located near the ends of
each apron piece.
Opposing holes for these dowels are located on the bottom of the
tabletop. Align the apron, and put into place. Repeat for 3
remaining sides.
Secure the apron pieces to the tabletop with the screws and
hardware provided.
* If using a power tool to assemble, be careful not to over tighten,
as this may cause damage to the table. All holes are pre-drilled
for ease and convenience.
!
Step Three
Align legs flush against apron.
*The pre-drilled holes on the legs should be facing inward.
Use the enclosed hardware and screws to attach the legs as shown
in the photo. Repeat process for remaining sides.
*Be careful not to over tighten the screws. This may cause the
wood to crack.!
Note:
Real wood expands and contracts, so the legs have adjustable felt feet. You may need to adjust seasonally
so the table may sit flat on even or uneven surfaces such as tile floors. Simply turn them left to increase the
leg height, or right to lower it.
!
!
!
!