Manual

5
Rear Installation
1. Place jack under the center of the ATV, just forward of where the rear drive shaft connects to the engine,
and lift until the weight is off the suspension. Be careful to secure the ATV properly so it is stable on the
jack.
2. Remove the rear wheels.
3. Disconnect the top of the sock from the shock mount.
4. Next remove storage box from the rear of the ATV. You will need to trim some plastic behind the box that
is near the top shock mount.
5. Next you will need to trim a small area of the plastic for bracket and bolt clearance.
6. Once you have trimmed the plastic insert the long rear bracket into place.