Manual

5. Insert the small spacer and top of the shock in the bottom of the lift racket.
6. Secure the shock, bracket, and small spacer using the 10x60 hex bolt and 10mm
lock nut.
7. Repeat steps for the opposite side.
8. Place the wheel back onto the ATV and torque lugs to factor specifications.
Rear Installation
1. Place jack under center of ATV rear end and lift until rear wheels clear the
ground. Be careful to support ATV properly so that it is securely supported but so
that A-arms and shocks can droop to full extension.
2. Remove rear wheels and shocks from the ATV.
3. Using a spring compressor, compress the shock and remove the stock spring.
4. Next, insert the spring stiffener onto the shock.
5. Place the stock spring(s) back onto the shock.