Owner manual

6
15. You will need to remove some material from the area where lower control arm
mounts to the frame. You will only need to remove a small area nearest the axle
boot.
NOTE: Do this before you install the A-arms!
16. Use the factory nuts and bolts to connect the new A-arms to the UTV. Each arm
is labeled relative to its location on the UTV. The location is determined from the
seated position. You will have left and right upper A-arms and left and right
lower A-arms.
17. Reconnect the caliper to the knuckle assemble, taking care to route the brake line
so that it does not inter fear with the axle bar. Secure the brake lines with the zip
ties provided in the kit.