User guide

1. Remove vacuum slide from carb. Remove stock needle & spacers, noting order of assembly.
2. Install Dynojet needle on groove# 4 for applications below 5000 feet, groove #3 for above 5000 feet, using all stock spacers. Install the Dynojet
washers above the E-clip.
3. Remove stock main jet and replace with Dynojet main provided. If you are running the the stock exhaust use the DJ132 below 3000 feet, DJ128
from 3000 to 6000 feet and DJ124 above 6000 feet. If you are running an aftermarket exhaust with a HIGH flow baffle use the DJ136 below 3000
feet DJ132 from 3000 to 6000 feet and the DJ128 above 6000 feet. Be sure that the jet you are changing is the main jet.
4. Locate the Fuel Mixture Screw. Using a flat blade screwdriver, turn the mixture screw clockwise until it seats, then turn out 3 1/2 turns .
STAGE ONE INSTRUCTIONS
This is Groove #1.
Q208.001
Fig. A
Fig. B
Fuel Mixture Screw