Tus neeg siv phau ntawv
24
ENGLISH
DESCRIPTION OF OPERATION
6
LEVEL
This controller determines the input sensitivity (adaptation to the output signal of the head unit).
9
AUTO TURN-ON
If your head unit does not have a turn-on signal (REM), you can use the automatic turn-on function of
the amplier. This works in two ways, which can be set at the AUTO TURN-ON switch:
DC: This method only works if you use the HIGH LEVEL INPUT wiring harness. The button switch
INPUT LEVEL must be in position HIGH. The amplier then detects a voltage rise to 6 volts when the
head unit is turned on by a so-called “DC offset” and then turns on the amplier.
VOX: Select this method when using the RCA jacks of the RCA wiring harness. The button switch
INPUT LEVEL CH1-6 must be in position LOW. The amplier then detects a voltage increase in the
incoming audio signal when switching on the head unit via the attached RCA cable and then switches
on the amplier.
Note: As soon as the head unit is switched off again, the amplier switches itself off.
8
7
6 8
7
9 10 11 12 13 14
LINE INPUT
Connect the LINE INPUTS with the head unit by using the included RCA wiring harness or the HIGH
LEVEL INPUT harness.
INPUT LEVEL
If you use the RCA wiring harness with the pre-amplier outputs of your head unit, this button must be
in position LOW. If you use the HIGH LEVEL INPUT wiring harness with the speaker outputs of your
head unit, this button must be in position HIGH.