User's Manual

25
4.9 Measured point
In the software functions of this series total station, we need
to retrieve or input the coordinates data of points in many places
as well as obtain the coordinate data by field measurements. The
method is as same as retrieving points. Take“Project->base” for
example.
Pt.1:
Project->base
MEAS
KNOWN
Pt.2:
ENT
A
1) Press the key [MEAS], then enter into the interface (as
shown below;
Meas. target
HR:
Vz:
SD:
*[Hot] to set T.H
MSR1
MSR2
m
45º23'53"
89º52'36"
2) The angle displays real time, and press [MSR1] or
[MSR2] to start measuring;
3) After a distance measurement is ended and successful
(if repeat mode or track mode, you should press [ESC]
to end.), enter the interface of saving data automatically.
After saving successfully, it will come back to the point
input interface, and refresh to display the saved point.
4.10 Retrieve code
On the interface with inputting code, you can input code by
retrieving.
1) Press [LIST] to enter the code list (as shown below),
and press [◄] or [►] to move cursor;