Use and Care Manual
10
Problem Cause Solution
Compartments are warmer than usual Control preset is set to warm • Lower the setpoint temperature. Refer
to changing the set point for the specific
model
Light is staying on •
Condenser is dirty or obstructed • Clean the condenser and clear
obstruction.
The door is open or has been opened more
frequently lately.
• Wait 24 hours and recheck the
temperature.
Internal louvers and/or the fan guard is
obstructed.
• Reset the preset temperature if necessary
– refer to page 4 and 5 of this guide.
• Make sure the louvers and/or the fan are
not obstructed.
Warm product product was recently placed in
the cabinet.
• Wait 24 hours for product to chill, then
recheck the temperature.
System runs for a long period of time. Condenser is dirty or obstructed. • Clean the condenser and clear the
obstruction.
Door was kept open for a long time or was
opened more frequently, or warm product
was recently placed in the cabinet.
• Wait 24 hours and recheck temperature.
Hot day and warm room temperature • Normal for the system to run more
frequently.
Condensation forms outside of the unit High humidity and/or frequent door opening • Normal Operation
Condensation forms inside the compartments High humidity and/or frequent door opening • Normal operation
Door is not closing and sealing properly • Make sure the door is closing properly.
Check the door seal and replace if
necessary.
• If condensation persists, contact Hestan
Technical Service at 888-905-7463
hestanhome.com
HESTAN OUTDOOR REFRIGERATION USE AND CARE MANUAL
Turn the manual light switch off.