Installation Guide

66
EAVE WALL R.H. DOOR HARDWARE
PARTS REQUIRED:
1/2" (13 mm) Drill Bit
1/4" (6 mm) Drill Bit
35-3/4"
(90 cm)
1/2"
1,3 cm
SIDE VIEW
Measure and mark location of hole on outside of right door as shown (Fig.A).
Pre-drill pilot hole with 1/4" dril.
Pre-drill through hole with 1/2" drill.
Keep drilled hole square
to trim to avoid breaking
edge of door stiffener.
You have nished installing your T-handle.
BEGIN
1
FINISH
4
2
3
Insert handle in hole and secure using 1-1/2" (3,8 cm) screws (Fig. B).
Attach inside handle and secure with set screw as shown.
x1
x2
1-1/2" (3,8 cm)
TOP VIEW
1-1/2"
3,8 cm
Go to page 71.
5-1/2" Shaft
x1
1-1/2"
(3,8 cm)
Fig. A
Fig. B
1-1/2"
(3,8 cm) x2
5-1/2"
Shaft
Set Screw