10x12 Hillsdale Instructions
63
PARTS REQUIRED:
EAVE WALL R.H. DOOR
Center door in wall panel opening.
Hold door in position and keep level.
Install door with black-painted hinge board.
4
FINISH
6
You have nished installing your single door.
Screw hinge boards into wall supports and oor using ve 3" screws as shown.
Make sure screws go into framing and oor (Fig. D, Fig. E).
5
3
2
3" (7,6 cm)
x5
3" (7,6 cm)
Screws into the wall
support and oor frame.
Measure Gap (Fig. B) between door trim and wall panel as shown.
Hold door in position and keep level.
Hinge-board must overhang wall panel at measurement shown (Fig. C).
Bottom of door trim is even with wall panel as shown.
Fig. A
Angle 3" (7,6 cm)
Screw
Fig. E
Fig. D
Fig. B
Fig. C
3/8"
(1,0 cm)
3/8"
(1,0 cm)
Door trim even
with panel.
Door
Frame
Flush
Carefully cut bottom wall frame 2 x 4 ush with door frame
using a saw (Fig. A).
Be careful not to cut into fl oor panel!
5/8"
(1,6 cm)
5/8"
(1,6 cm)
5/8"
(1,6 cm)
5/8"
(1,6 cm)
x1
Painted
Black
on Ends
BEGIN
1
UNIVERSAL DOOR
Right