User's Manual

Chapter 3 Wireless LAN Access
Point Configuration
3.1 Getting Started
This Access Point provides web-based configuration tools, allowing you to
configure from wired or wireless stations. Follow the instructions below to
configure the device.
From Wired Station
1. Make sure your wired station has the same subnet address as the access
Point.
The default IP Address and Sub Mask of the access point are:
Default IP Address: 192.168.1.240
Default Subnet: 255.255.255.0
Configuring your PC to have the same subnet as the access point.
1a) Windows 95/98/Me
1. Click the Start button and select Settings, then click Control Panel. The Control
Panel window will appear.
2. Double-click Network icon. The Network window will appear.
3. Check your list of Network Components. If TCP/IP is not installed, click the Add
button to install it now. If TCP/IP is installed, go to step 6.
4. In the Network Component Type dialog box, select Protocol and click Add
button.
5. In the Select Network Protocol dialog box, select Microsoft and TCP/IP and then
click the OK button to start installing the TCP/IP protocol. You may need your
Windows CD to complete the installation.
6. After installing TCP/IP, go back to the Network dialog box. Select TCP/IP from