Instructions / Assembly

Table Of Contents

Snowfall Creek Pre-Lit Wreath-24"

Item # DCWR2402

To set up:

1) Place the wreath on a flat surface. Straighten and separate all branch tips. To achieve

maximum fullness, tips should not touch one another.

2) From back of the wreath, find the battery box and open it. Insert 3AA batteries into the

battery box then close it (see Figure A, B, C, D & E). *When using outdoors, locations with

temperatures -10 or colder we recommend using lithium batteries. Suitable for indoor use

and outdoor under covered porch.

3) Each battery box is featured with a 3-position switch: On – Off – Timer (see Figure F). The

timer enables the LED lights to remain on for 6 hours, then off for the next 18 hours. This

will repeat daily.

PAGE 1
Snowfall Creek Pre-Lit Wreath-24" Item # DCWR2402 To set up: 1) Place the wreath on a flat surface. Straighten and separate all branch tips. To achieve maximum fullness, tips should not touch one another. 2) From back of the wreath, find the battery box and open it. Insert 3AA batteries into the battery box then close it (see Figure A, B, C, D & E). *When using outdoors, locations with temperatures -10 or colder we recommend using lithium batteries. Suitable for indoor use and outdoor under covered porch.
PAGE 2
ATTENTION: 1. Adult supervision is necessary when changing and disposing of batteries. 2. Slide switch to "OFF" position when changing batteries. 3. Confirm proper polarity when inserting batteries (See Fig. 1). 4. Do not attempt to charge non-rechargeable batteries. Only recharge rechargeable batteries and do it under adult supervision. 5. Do not mix old and new batteries or batteries of different types. 6. Replace batteries when the light is faint. 7. Replace all batteries at the same time. 8.