Manual

IS-25 Issue: 4 Date: 19.06.12 C/Note: 11759 Page 1 of 3
DATAMATE ASSEMBLY TOOL Z80-280
Extraction Tool (Female contacts L-Tek and J-Tek)
Extraction Tool (Male contacts L-Tek only)
Extraction Tool (Male contacts J-Tek only)
Insertion Tool (for insulation up to Ø0.9mm)
Insertion Tool (for insulation from Ø0.9mm to Ø 1.1mm)
INSERTION PROCEDURE
1. Strip the wire and crimp the socket onto the wire, ensuring that the correct part is used (see
Instruction Sheet IS-01, Hand Crimp Tool M22520/01).
2. Ensure all parts (moulding and crimp sockets) are clean and ready for final assembly.
3. Select the appropriate insertion tool for the wire size in use and attach to the handle. The
different tools can be found by unscrewing the cap at the end of the handle (see above for
tool identification).
4. Place the crimped contact partially into the moulding. The correct position is reached when
approximately 1.5-2mm of socket protrudes (see Figures 2 and 3).
5. Place the insertion tool over the wire, with the wire sitting in the groove and the tool
resting on the back of the crimped socket (see Figure 1).
6. To complete the assembly, push firmly on the rear of the contact while ensuring the tool
remains perpendicular to the mould face. There will be an audible click when the socket is
correctly seated within the moulding.
Harwin North America Harwin Europe Harwin Asia
T: [phone] F: [phone] T: [phone] F: [phone] T: [phone] F: [phone]
E: [e-mail] W: www.harwin.com E: [e-mail] W: www.harwin.com E: [e-mail] W: www.harwinasia.com
Insertion/Extraction Tool Holder