Declaration of Conformity
14221-1800-2000, Rev. M
27
For more rigorous cleaning, use the following procedure:
CAUTION
1.
Apply the cleaning solution to a clean damp cloth and clean the radio.
NOTE
2.
Wipe off the radio with clean damp cloth using mild warm soapy water.
3.
Follow up by wiping off the radio with clean damp cloth using warm water only.
4.
Wipe dry with clean cloth.
4.6 OPTIONS AND ACCESSORIES
Only use Harris approved accessories. Refer to Harris’ Product and Services catalog for the complete list
of options and accessories available. Contact Harris for requirements not contained in this list:
CAUTION
CAUTION
Table 4-1: Options and Accessories
DESCRIPTION PART # XL-200P OPTION # XL-185P OTION #
ANTENNAS
Full Spectrum Antenna 14035-4000-01 XL-NC5Z XS-NC5Z
Wideband Whip Antenna 378-520 MHz,
762-870 MHz
14035-4420-01 XL-NC8E XS-NC8E
¼ Wave Whip Antenna, 762-870 MHz 14035-4440-02 XL-NC8F XS-NC8F
½ Wave Whip Antenna, 762-870 MHz 14035-4440-01 XL-NC8D XS-NC8D
¼ Wave Whip Antenna, 762-944 MHz XL-
185P Only
14035-4450-02 NA XS-NC8L
½ Wave Whip Antenna, 762-944 MHz XL-
185P Only
14035-4450-01 NA XS-NC8K
½ Wave Whip Antenna, 890-960
MHz XL-185P Only
E75-0286-001 NA NA
½ Wave Whip Antenna (764
–
870 MHz) KRE1011506/1 XL-NC5K N/A
¼ Wave Stub Antenna (764 – 870 MHz) KRE1011506/2 XL-NC5X N/A
Helical VHF KRE1011219/2 XL-NC1C N/A
BATTERIES/CHARGERS
Battery, Li-Ion, 3100 mAH, UL 14035-4010-05 XL-PA3X XS-PA3X
Battery, Li-Ion, Hi-Capacity, 4800 mAH 14035-5050-01
Battery, Li-Ion, Hi-Capacity, 4800 mAH, C1D2
14035-5050-02
Battery, Li-Ion, 3100 mAH 14035-4010-04 XL-PA3V XS-PA3V
Do not use chemical cleaners, spray, or petroleum-based products. They may damage
the radio housing. We recommend using Calla 1452 or equivalent.
Do not spray cleaning solution directly on radio. To clean the radio in the speaker and
microphone areas, carefully wipe these areas but prevent the cleaning solution from
entering the speaker or microphone openings.
Always use the correct options and accessories (battery, antenna, speaker/mic, etc.) for
the radio. Immersion rated options must be used with an immersion rated radio. Refer
to Table 4-1.
Refer to Section 3 for radios with C1D2 or C1D1 options.