User Manual
Table Of Contents
- 1 REGULATORY AND SAFETY INFORMATION
- 1.1 SAFETY SYMBOL CONVENTIONS
- 1.2 RF ENERGY EXPOSURE AWARENESS AND CONTROL INFORMATION FOR FCC OCCUPATIONAL USE REQUIREMENTS
- 1.3 COMPLIANCE WITH RF EXPOSURE STANDARDS
- OCCUPATIONAL SAFETY GUIDELINES AND SAFETY TRAINING INFORMATION
- 1.5 COMMON HAZARDS
- 1.6 SAFE DRIVING RECOMMENDATIONS
- 1.7 OPERATING RULES AND REGULATIONS
- 1.8 OPERATING TIPS
- 2 SPECIFICATIONS
- 3 INTRODUCTION
- 4 UNPACKING AND CHECKING THE EQUIPMENT
- 5 PLANNING THE INSTALLATION
- 6 ANTENNA INSTALLATION
- 6.1 ANTENNA MOUNTING LOCATIONS
- 6.2 ANTENNA INSTALLATION PROCEDURES
- 6.2.1 Installing NMO Antenna Mounts AN125001-001, 002, 003 and 004
- 6.2.2 Installing NMO Magnetic Antenna Mounts AN125001-007 and AN125001-008
- 6.2.3 Installing All Other Antenna Mounts
- 6.2.4 Attaching NMO Antenna Elements
- 6.2.5 Installing the Coax Cable and TNC RF Connector
- 6.2.6 Install GPS Antenna (Required Only if Radio has GPS Receiver Option)
- 7 FRONT-MOUNT RADIO INSTALLATION
- 8 REMOTE-MOUNT RADIO INSTALLATION
- 8.1 MOUNTING THE REMOTE-MOUNT RADIO
- 8.2 REMOTE-MOUNT RADIO’S DC POWER INSTALLATION
- 8.3 CH721 CONTROL HEAD INSTALLATION
- 8.4 HHC731 HAND-HELD CONTROLLER INSTALLATION
- 9 SPEAKER INSTALLATION
- 10 MICROPHONE ATTACHMENT
- 11 OPTIONAL CABLES
- 12 GPS NMEA-FORMATTED SERIAL DATA CONNECTION
- 13 INITIAL POWER-UP TEST
- 14 PERFORMANCE TESTS
- 15 COMPLETE THE INSTALLATION
- 16 WARRANTY REGISTRATION
- 17 WARRANTY
MM-014763-001, Rev. G
99
11.4 ACCESSORY CABLE 19B802554P24
When a remote-mount radio installation employs the HHC-731 hand-held controller, Accessory Cable
19B802554P24 is required to make connections to an external siren and light control system. This cable’s
male DB-25 connector, identified P1, mates to the female DB-25 connector of HHC-731 Interface Cable.
The cable’s assembly diagram is illustrated in Figure 11-4 below.
Connector J1 mates with a cable provided with the siren and light control system. The respective
connection procedure is presented in Section 8.4.6 of this manual.
Connector P2 is not used in this application of the cable.
(Made From 19B802554 Rev. AD, Sh. 24)
Figure 11-4: Accessory Cable 19B802554P24
0.6 meters
(23.6 inches)
1.75 meters
(68.9 inches)