Installation Instructions

Integration and Test, RBS 884 Pico (850 MHz and 1900 MHz)
– I = Initiate Commands
– R = Reset/Restore Commands
• ! An exclamation mark signifies the start of a comment.
Note: When using TRAB2 with magazine number BFDH 511 501/3,
the devices are MBTRAC, the switching network terminal
is MBTRACS (i.e. ROF 137 7994/1 R1A) and the board is
MBTRAB. When using TRAB3 with magazine number BFDH
511 501/5, the devices are MBTRC, the switching network
terminal is MBTRCS (ROJ 207 202/2 R1A) and the boar
dis
MBTRB. Refer to Table 5-1 on page 5-4.
Table 5-1. TRAB2 and TRAB3 Terminology Comparison
TRAB Device Switching
Network Terminal
Board
TRAB2 with
magazine
BFDH 511 501/3
MBTRAC MBTRACS MBTRAB
TRAB3 with
magazine
BFDH 511 501/5
MBTRC MBTRCS MBTRB
2 Safety Regulations
2.1 Voltage Hazards
DANGER!
Hazardous voltages over 100 V are used in the operation of this equipment.
Observe safety precautions. Contact with line power (AC supply) can be
fatal. Do not be misled by the term low voltage. Under certain conditions,
listed potentials as low as 50 V can be fatal.
Always observe the following:
5-4 1532-AE/LZB 119 3834 Uae Rev PA4 2001-04-04