Installation Sheet

Plastic Pie-Cut Lazy Susans

Installation Instructions for the

PLSP Series

IMPORTANT:

Before you begin, make sure you familiarize yourself with all the

parts and fully read the instructions.

CUSTOMER SERVICE:

Toll free customer help line available weekdays between 7:00am

and 6:00pm Central Time at 800-463-0660.

TOOLS NECESSARY:

Screw gun or Phillips screwdriver. NOTE: If screw gun has a clutch,

set to lowest setting so as not to over tighten and/or strip screws.

STEP 1

Install Upper and Lower Mounting Brackets

Lower Mounting Bracket Upper Mounting Bracket

Mark layout for lower mounting support by placing the template

on the bottom cabinet surface tight against the back of the

face frame (for frameless cabinets, set the template back 3/4”).

Follow the template for the appropriate size lazy susan and mark

mounting locations A and B shown above.

Using the template, in the same way mark the mounting location

for the Top Mounting Plate.

Place the Bottom Shelf Support on the lower marks and secure

with two (2) - #8 x 1/2” Pan Head Phillips Wood Screws to the

bottom of the cabinet as shown.

Install with four (4) - #8 x 1/2” Pan Head Phillips Wood Screws.

A Template 1X

B Lower Mounting Bracket 1X

C Top Mounting Plate 1X

D Plastic Pie-Cut Shelf 2X

E Height Adjustor 1X

F Positive Stop 1X

G Telescopic Twist-Lock Pole 1X

H Shelf Pin 2X

I #8 x 1/2” Pan Head Phillips Wood Screw 14X

#8 x 1/2” Pan

Head Phillips

Wood Screws

Scan to watch the installation video

http://delivr.com/285UG

PAGE 1
Plastic Pie-Cut Lazy Susans Scan to watch the installation video http://delivr.com/285UG Installation Instructions for the PLSP Series IMPORTANT: Before you begin, make sure you familiarize yourself with all the parts and fully read the instructions. CUSTOMER SERVICE: Toll free customer help line available weekdays between 7:00am and 6:00pm Central Time at 800-463-0660.
PAGE 2
STEP 2 - Pole Assembly STEP 3 - Shelf and Pole Assembly A B A B C D C D (A) Adjust the nut on the height adjuster so that about 1/8” of the threads are showing below the nut. (B) Insert the height adjuster into the end of the pole as shown, making sure that the guides line up with the slots in the pole. (C & D) Then insert the height adjuster into the positive stop as shown. Slide the top of the pole through both shelves. Work the pole and shelf assembly into the cabinet.