Installation Sheet

IMPORTANT:

Before you begin, make sure you familiarize yourself with all the

parts and fully read the instructions.

CUSTOMER SERVICE:

Toll free customer help line available weekdays between 7:00am

and 6:00pm Central Time at 800-463-0660.

TOOLS NECESSARY:

Screw gun or Phillips screwdriver and tape measure. NOTE: If

screw gun has a clutch, set to lowest setting so as not to over

tighten and/or strip screws.

PARTS IDENTIFICATION:

A Base Filler Pullout 1 pcs

B C-Frame with Base 1 pcs

C Outer Skin 2 pcs

D Skin Brace 2 pcs

E #8 x 5/8 Flat Head Phillips Wood Screws 4 pcs

“No Wiggle” Base Filler

Installation Instructions for the BFPO2 Series

STEP 3

Screw in ller from the adjacent cabinet (hardware not

included).

STEP 4

Loosen door mounting bracket screws.

STEP 2

Align ller behind adjacent cabinet face frame or 3/4” oset

from front on frameless.

STEP 1

Remove shipping screws located on the back and bottom of

ller.

Back shipping screws

Bottom shipping screws

PAGE 1
“No Wiggle” Base Filler Installation Instructions for the BFPO2 Series IMPORTANT: Before you begin, make sure you familiarize yourself with all the parts and fully read the instructions. STEP 1 STEP 2 CUSTOMER SERVICE: Toll free customer help line available weekdays between 7:00am and 6:00pm Central Time at 800-463-0660. TOOLS NECESSARY: Back shipping screws Screw gun or Phillips screwdriver and tape measure.
PAGE 2
STEP 6 STEP 5 STEP 7 Up/Down adjustment (+/- 1/4”) A Face frame Center of mounting bracket slot to estimated top of door Tilt adjustment (up to + 1/4”) C B Door mounting set screws Door frame Left/Right adjustment (+/- 7/8”) Full extension (+2-1/2”) Loosen door mounting bracket screws. Loosen the door mounting set screws and slide bracket out to desired position to attach to the door rail. Measure from the center of the slot on the door mounting bracket to the estimated top of door.