User Manual
Table Of Contents
- overview
- One-way camera
- LED parking indicator light
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
LED parking indicator light
28_ LED parking indicator light
Assembling the cover
1. Turn the 6 fixing screws for the body protection cover clockwise to fix the body protection cover with the
provided Torx L wrench.
TR20
6x
2. Place the skin cover all the way over the body protective cover, and then press 2 front parts of the skin
cover as shown in the figure below.
3. With the provided Torx L wrench, turn the 2 fastening screws for the skin cover on the rear of the product
clockwise.
TR20
2x
Outdoor installation
When you install the product outdoors, it should be waterproofed with waterproof butyl rubber tape (which
can be purchased in stores) so that water does not leak from the gap of the cable connected in the outdoor
area.
1. Connect the LAN cable and the power cable.
2. Wrap the black cable jacket (Area A) and the cable connection
area with waterproof (butyl rubber) tape so that more than half of
the butyl rubber tape is overlapped.
J
`
If the cable jacket is not waterproofed properly, then it can directly cause
leakage. Make sure to protect the cable with a dense layer of taping.
`
Waterproof butyl tape is made of butyl rubber that can be stretched to twice
its normal length.