Instructions / Assembly

LIGHTING INSTRUCTIONS

Warning: If these instructions are not followed exactly, a fire or explosion may result in

causing property damage, personal injury or loss of life.

1. Make sure the control knob is in the "OFF" position. See Figure 12 Open the tank

valve all the way.

2.Push in the igniter button. You will hear a slight clicking sound. With the igniter button

pushed in, push and turn the control knob to the “ON” position. The fire should light

within a few seconds. Once the flame is lit, release the igniter button and continue to hold

the control knob in for 10 to 15 seconds. Release the control knob. The control knob

should pop back out and then remain lit.

Note: If the fire does not light, turn the knob to the “OFF” position and wait five (5)

minutes before trying again.

3. To turn down the flame, push the control knob in slightly and turn to Medium (medium

or Low (small flame).

4. To shut down the fire pit, turn the control knob to the “OFF” position and turn off the

tank valve.

MAINTENANCE

The flames should look like those in Figure 13 To clean

the burner, use a soft brush after the burner has cooled

completely. Never use a vacuum cleaner on the burner.

It is recommended that the fire pit is stored indoors

during the winter if it will be subjected to freezing

temperatures. The LP cylinder must be disconnected

and removed from the appliance before the appliance

can be stored indoors.

Figure 13

IGNITER BUTTON CONTROL KNOB

Figure 12