Use and Care Manual
10
LIGHTING INSTRUCTIONS
1. Locate the control and igniter panel. Make sure
the control knob is in the “OFF” position. See Figure
12.Open the tank door and open the tank valve all
the way.
2. Push in the igniter button. You will hear a slight
clicking sound. With the igniter button pushed in,
push and turn the control knob to the “ON” position.
The fire should light within a few seconds. Once the
flame is lit, release the igniter button and continue
to hold the control knob in for 10 to 15 seconds.
Release the control knob. The control knob should
pop back out and the fire should remain lit. Note: If
the fire does not light, turn the knob to the “OFF”
position and wait five (5) minutes before trying
again.
3. To turn down the flame, push the control knob in
slightly and turn to the Medium (medium flame) or
Low (small flame).
4. To shut down the fire pit, turn the control knob to
the “OFF” position and turn off the tank valve
Figure 12